Causes of burrs when laser cutting machine cuts carbon steel

When the laser cutting machine cuts carbon steel, there are burrs at the bottom of the cutting surface. The main reasons are:

1. Focus issues. The focus position of the laser is wrong. You can solve this problem by adjusting the focus.

2. Laser output power problem. First check whether the laser is normal. On the premise that the laser is working normally, further check whether the output power of the laser matches the required power of the plate. If it does not match, it needs to be adjusted.

3. Cutting speed problem. If the cutting speed is too slow, it will also cause burrs on the bottom of the cutting surface. At this time, the cutting speed needs to be increased.

4. Gas problems. The purity of the gas can also affect the quality of cutting. When the purity of the gas is insufficient, this kind of problem will also occur, and it is necessary to replace the gas with a higher purity for cutting.

5. The working time of carbon steel laser cutting machine. When the machine continues to work for more than a certain period of time, such problems may also occur. At this time, you need to restart the machine to try.

sample


Post time: Aug-13-2020

Send your message to us:

Write your message here and send it to us